-
July 12th, 2016, 12:11 PM
#1
Polling connection from iOS
Hello,
is there a way to go back to a 'stream' connection after the LS client library switched to a polling connection? I simulated a network problem (actually I just set a breakpoint and waited...) and the client library, after resuming, switched to the polling mode (since the enableStreamSense was set to YES). I started to get a lot of binding_session, that actually simulate a stream connection, but how long the polling mode will continue? Does the LS client library have the ability to detect that the network is functioning correctly and switch, automatically, from polling mode to the stream again?
Thank you
Similar Threads
-
By Anatoly Gurfinkel in forum Client SDKs
Replies: 9
Last Post: July 6th, 2015, 04:24 PM
-
By benthemos in forum Client SDKs
Replies: 4
Last Post: February 27th, 2015, 06:58 AM
-
By tony99nyr in forum Client SDKs
Replies: 3
Last Post: June 26th, 2014, 02:03 PM
-
By chanro4 in forum Client SDKs
Replies: 1
Last Post: January 19th, 2011, 10:23 AM
-
By rsouissi in forum Client SDKs
Replies: 3
Last Post: February 1st, 2008, 08:49 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT +1. The time now is 11:21 PM.
Bookmarks